(1) Before disassembling the interior of the speed reducer, the mud and rubbish stuck to the top of the reducer should be completely removed, and the mark before the disassembly should be stamped. Then, check the appearance of the reducer (especially the gasket, the oil leakage at the joint surface, etc.); (2) The meshing parts of the internal planetary gear train must also be stamped before disassembly; (3) The parts that have been disassembled should not contain mud or rubbish as much as possible. If there is any damage, they will degrade the performance and even damage the machine. Therefore, the mixer must be used with great care; (4) It must be cleaned with cleaning agent. The use of highly volatile gasoline, thinners, trichloroethylene, etc. will cause damage to gaskets, O-rings, and paints, so use absolutely must be avoided. (5) Decomposition must be careful not to mix the foreign matter inside the reducer; Assembly (1) The components of the concrete mixer truck must be cleaned prior to assembly. The attached mud, garbage, etc. must be removed, and the assembled components must be assembled without any damage. (2) Replaced O-rings, in principle, can not be used again, if it is necessary to continue to use, to confirm that there is no scars, peeling, crushed, etc. can be used; (3) After assembly, reload the vehicle and lubricate. Deep Hole Drilling Machine,Gun Drill Machine,Box-type Vertical Drilling Machine,Drilling Machine Column WEISS MACHINERY CO., LTD. , https://www.weissmachinerys.com
General considerations for disassembly and assembly: