The powder material transportation vehicle and the tanker truck are somewhat similar in appearance. The top of the tank body is equipped with a manhole cover, so that some customers will ask whether the loading and unloading process of the powder material transportation vehicle and the tanker truck is the same. what is the difference? Next, Xiao Bian talked about the loading and unloading process of the powder material transporter and tanker. First of all, the loading of the powdered material transporter is directly from the tank cover. The external power will directly drive the powdered and granular materials into the tank body. The discharge is operated by the on-board air compressor and is explained through the internal fluidized bed mechanism of the tank. Powder particles are discharged from the tank. General cement plants have storage silos, open the silt material transporter to the storage silo with a unloading port aligned with the cement tank can be directly loaded! The tanker loading and unloading oil is different from the powdered material transporter. There are two methods for the tanker, whether loading or unloading, and the shipping oil can be directly loaded from the tank mouth or through the on-board oil pump. Link the pipe and pump it directly from the pump inlet. The unloading oil can be self-flowing, like the water flow, it can also be pumped out, and the unloading process can be realized by the pressure of the pump. The powdered material transporter transports fly ash, cement, lime powder, ore powder, granule base, etc. The particle diameter is not more than 0.1mm. Tankers transport petroleum derivatives (gasoline, diesel, crude oil, lubricating oil, coal tar, etc.) and are dangerous goods carriers. The loading and unloading process of the powder material transporter and tanker should pay attention to safe handling.
Hot Mirror : Reflect IR Cold Mirror: Reflect Visible
A cold mirror is a specialized Dielectric Mirror, a Dichroic Filter, that reflects the entire visible light spectrum while very efficiently transmitting infrared wavelengths. Similar to hot mirrors, cold mirrors can be designed for an incidence angle ranging between zero and 45 degrees, and are constructed with multi-layer dielectric coatings, in a manner similar to interference filters. Cold mirrors can be employed as dichroic beamsplitters with laser systems to reflect visible light wavelengths while transmitting infrared.
Hot Mirror,Cold Mirror,Hot Melt Mirror,Hot And Cold Mirrors Changchun Ruiqi Optoelectronics Co.,Ltd , http://www.ruiqi-optics.com
