The annual inspection of Dongfeng Sewage Sewage Vehicle and suction truck cannot pass. The most common phenomenon is that the detection of the vehicle lamp is not up to standard. With the increase of vehicle use time, circuit aging, power shortage, etc., will cause the brightness and transparency of the lights is not enough. Or it is because when running at a high speed, the surface of the lampshade is seriously worn, which affects the light transmittance of the suction truck and the suction truck headlights. Or replace the non-original brand wick and attach a colored film to the headlights. At the same time, regardless of whether the brightness is up to standard, if it is a privately-modified headlight, or personalized headlights, its appearance and travel permit on and off, will also affect the vehicle inspection. Therefore, the usual driver friends should regularly clean the lampshade, check whether the fine road is aging, try to replace the original car lights. Another reason that the sewage suction trucks and suction trucks cannot pass the annual inspection is the brake failure of the vehicle. During the annual inspection, the problem of braking of the vehicle is often seen more carefully. In addition to the normal brake, the manual braking is also a key point of detection. When the brake pads wear out badly, it will affect its braking performance. Therefore, the driver must develop proper driving habits, and usually pay more attention to the warning light of the instrument panel, properly extend the service life of the handbrake device, and regularly check and replace the brake pads. Some sewage suction trucks and suction truck drivers forget to complete the vehicle traffic violation record before the annual inspection. In fact, each motorized vehicle inspection station generally has a place where traffic violations are queried. Drivers can inquire before testing. Refit sewage suction trucks, suction truck front and rear bumpers, pedals around the body, rear wing, exhaust pipe, tires, personality wheels, etc., these changes in the appearance of the body can not pass the annual inspection. Therefore, it should try to keep the appearance of the body consistent with the driving permit, so as not to affect the annual inspection. The unsatisfactory discharge of tail gas from sewage suction trucks and suction trucks will also affect the failure of annual inspections. Drivers should always try their best to maintain good driving habits and regularly do maintenance to extend the service life of these mechanical devices. Sewage suction trucks and suction truck tires are damaged more severely and will also affect the annual inspection. Therefore, car drivers should regularly check tires, and those who have problems should be replaced in a timely manner. Pillow Block Bearings,The Pillow Block Bearing Series,Ff12 Pillow Block Bearings,Pillow Block Bearing UKL Bearing Manufacturing Co., Ltd., , https://www.bearingukl.com
Sewage suction vehicles and suction truck drivers take time each year to conduct annual inspections, but sometimes they are unable to pass because of minor problems. This makes them very distressed. Well, what factors will cause the annual inspection to fail, let's give a big explanation here so that everyone can be prepared.