The traffic conditions in the city are getting worse and worse, and stop-and-go when traffic jams make it difficult for the owner to open the car. Therefore, a light, easy-to-use automatic car almost becomes the first glare for most urban people. Although the automatic car is easy to use, the automatic transmission system is a very sophisticated assembly, especially an automatic automatic transmission. Its structure is more complicated. Therefore, once the automatic transmission fails, it can be very troublesome and expensive to repair. In view of this, automatic transmissions require more careful care and maintenance. Check transmission oil regularly The automatic transmission is filled with a lubricant called ATF. Its role is not only lubrication and cooling, but also the transmission of power between the engine and the transmission. The working temperature of ATF oil is generally around 120 degrees Celsius, so the oil quality is very high and must be kept clean. Always check the automatic transmission fluid level is normal. The inspection method of automatic transmission oil is different from that of engine oil. The engine oil is checked under cooling condition, and the transmission oil is required to preheat the oil to about 50°C, and then the gear lever is left in each gear for 2 seconds. When parking, the normal oil level of the dipstick should be between the highest and lowest line. If not, add the same quality oil. Generally no matter if it is a manual transmission or an automatic transmission, it is recommended to replace the automatic transmission oil for a maximum of 12 months or 20,000 kilometers. In addition, the operating manual of some models may read 24 months or 40,000 kilometers for replacement. However, these are only suggestions under normal circumstances. Due to special conditions in Beijing, windy and sandy weather, road congestion, and poor air quality, it is recommended that vehicles regularly check ATFs regularly. Correct replacement of transmission oil Generally when replacing the automatic transmission oil, the screws used to remove the oil in the bottom of the automatic transmission are used to remove the old oil and then add new oil. However, only about 30% of the new oil can be replaced with 70% of the old oil. It still remains in the gearbox. If you change the oil by dismantling the oil pan, you can achieve a 70% oil change rate, which in fact can already ensure the health of the gearbox. However, the current better oil change method is dynamic oil change, and special gearbox cleaning equipment is used. During the operation of the gearbox, the old oil is fully circulated and discharged, and then the new transmission oil is added to make the oil change. The rate is as high as 90%. GM, Toyota, Ford and other brands of automatic transmissions have different friction coefficients, so ATF oils are different and cannot be mixed. Mixing ATF will cause damage to the friction plates of the gearbox, resulting in slippage of clutches and brakes, and severe damage to the friction plates. High Frequency Welded Finned Tube Simcan Industrial Equipment Co.,Ltd. , https://www.simcanindustry.com