Artificial Golf Green,Artificial Lawn Grass,Garden Artificial Turf,Outdoor Artificial Grass Shenzhen New Gaopin Sports Goods Co,Ltd , https://www.newgaopins.com
The HC series I-beam blocks are divided into medium-load type, heavy-load type, and light-load type. The I-beam blocks therefore have three types of wheels: Ф80, Ф63, and Ф50. The load capacity is ≤ 50∽150kg. The number of slabs is divided into single layer, double layer and three layers. There are three types in each type. The first end of the I-steel block is a cable tractor and the terminal is a fixed thread rack.
1. After the I-steel block has been fixed, the rear side should be attached with a baffle.
2, adjust the traction head, I-beam block car so that the trolley does not touch the upper and lower edges of the traction hole as a whole.
3, the cable length is 1.2 times the crane span plus 8 meters.
4, adjust the traction steel wire rope, I-beam to make its length less than the length of the same section of cable, run by the traction rope force.
5, I-steel block When the cable diameter is not equal, the cable clamp should be cushioned with a soft rubber, so that the outer diameter is basically the same, in order to clamp the cable.
6. When distributing cables, consideration shall be given to the balanced force of the two cable trays.
7, when the cable pulley for the second floor, three floors, the same requirements.
8. The double washers on the I-steel block device are adjusting washers. When the guide rails are not suitable, the washers are placed on the inner side of the fixing plate to adjust the width of the gauge. The guide rail is I100*68*4.5 and I120* when leaving the factory. Made of 74*5, I140*80*5, I160*88*6. Non-standard pulley processing according to drawings.
The HC-type I-beam block series provides a conductive form for the crane trolley. The I-beam block consists of walking wheels, brackets and pallets. The flexible cable is fixed on the pallet and the traction frame is synchronized with the cable pulley. Trolley power supply purpose.