Before using the charger to charge the electric forklift , it is necessary to first connect the charger's power cord to the mains power supply. It is necessary to intervene in an AC380V or AC220V power supply according to the labeling of the electric forklift's charger; then the charger and battery wires are The connection is good; open the battery dust cover of the electric forklift, this is a comparative advantage of the electric forklift has a very good cooling effect when charging; this time the charging switch can be opened to charge. After filling up the amount of points, turn off the on/off button of the charger and unplug the battery connector and the power plug of the electric forklift. Check carefully whether the electrolyte of the battery of the vehicle is in the normal range. If the electrolyte is not Sufficient, then need to increase the distilled water immediately to enable it to reach a normal use level. Electric forklift use note: 1. When the electric forklift needs to be charged, the charging place should be a fixed site, and the charging place should have a good ventilation environment, low humidity, and can not have any suspicious flammable objects. 2. The ground of the charging field fixed by the electric forklift should be easier to drain and cut acid. Because when the vehicle is charging, it is very likely that electrolyte will drip onto the ground. 3. When the battery of an electric forklift is being charged, it will generate hydrogen, so don't smoke around it when it is charging or let any fire source come close to it. If an explosion occurs, it will be a tragedy. 4. During the entire process of charging the vehicle, be careful not to force the plug of the battery to be pulled out. If there is an electrical spark, it will be very dangerous. 5. If the electrolyte is dripped after the battery is charged, the electrolyte needs to be flushed with clean water, and the electrolyte remaining on the battery of the electric forklift is also required to be washed out. 6. The electrolyte in the battery of an electric forklift is corrosive and toxic. Therefore, no matter what the operating conditions, care must be taken to avoid contact with the electrolyte in any part of the body. 1. Common carbon structural steel: carbon structural steel is divided into 5 grades according to the yield strength of steel: Q195, Q215, Q235, Q255, Q275. Each brand is divided into A, B, C and D grades due to its different quality. Q195, Q215, Q235 good plasticity, can be rolled into steel plate, steel bar, steel pipe, etc. Q255, Q275 can be rolled into steel, steel, etc. Carbon Steel Coil,Low Carbon Steel Coil,Hot Rolled Coil,Ss Coil Shandong Panhua Metal Material Co. LTD , https://www.panhuametal.com
2. High quality carbon structural steel: steel number is expressed by the average mass thousandth fraction of carbon element content. Such as 20#, 45#, etc. Application: Mainly used for manufacturing various machine parts.
3. Carbon tool steel: steel grade is expressed by the average mass thousandth fraction of carbon element content, and preceded by T. Such as T9, T12, etc. Purpose: Mainly used for manufacturing various cutting tools, molds, measuring tools, etc.
4. Cast steel: Cast steel number is preceded by ZG. Purpose: Mainly used for manufacturing parts with complex shape and need certain strength, plasticity and toughness, such as gears, couplings, ect.