1. When the ultrasonic vibrator is damped, you can use a megohmmeter to check the plug connected to the transducer. Check the insulation resistance value to determine the basic situation. Generally, the insulation resistance must be greater than 5 megohms. If this insulation resistance value is not reached, the transducer is generally damp, and the entire transducer (excluding the plastic housing) can be placed in an oven and set to dry at about 100°C for 3 hours or using a hair dryer to reach the resistance value. Normal so far. 2. When the transducer vibrates and the ceramic material breaks, it can be inspected with the naked eye and the megohmmeter. Generally, as an emergency treatment measure, the individual damaged vibrator can be disconnected without affecting the normal use of other vibrators. 3, vibrator degumming, our transducer is the use of cementation, screw fastening dual guarantee process, in normal circumstances will not happen. 4, stainless steel vibration surface perforation, the general transducer full load after 10 years may appear vibration surface perforation. Others Stainless steel wire mesh Others Stainless Steel Wire Mesh,Stainless Wire Mesh,Stainless Mesh Screen,Stainless Steel Woven Wire Mesh Anping Xinghong Metal Wire Mesh Co.,Ltd , https://www.xinghongmetal.com