Semi-Metallic Motorcycle Brake Pads Disc Brake Pads,Performance Brake Pads,Semi Metallic Brake Pads,Semi-Metallic Motorcycle Brake Pads Wenzhou Tuxing Automobile and Motorcycle Parts Co., Ltd. , https://www.txmotorparts.com
2. Clean up the debris in the barrel.
3, the cylinder should be limited before starting to start.
4, the direction of rotation of the stirring shaft should be marked as the end of the cylinder.
5, the loading of materials must remove metal and other debris.
6. Adjust the timing of the stirrer according to the stirring time, and note that it must be adjusted under power off conditions.
7. Press the start button, the spindle will drive the shovel operation.
8, stop automatically after the set time.
9, when the unloading should first stop, set the pin, move the handle to rotate the barrel to a certain position, and then the locking pin positioning spindle rotation, so that mixing material discharge tube.
10. After the mixing material is drained, the manual cylinder is reset, and the stirring tube is positioned and pinned.
11. The cleaning cylinder can pour water into the cylinder so that the main shaft can be rotated for flushing. Dry sand cleaning can also be used.
Single-shaft concrete mixer maintenance 1. Regularly lubricate the bearing components according to the conditions of use, and the gearbox lubrication refers to the instruction manual of other products.
2. Regularly check the sealing condition of the machine: If any leakage is found, check the quality of the gasket in time.
3. Always check the firmness of the blade. If loose, tighten it in time.
4, always check the electrical control system is in good contact and dry.
5. After the mixer is used for a long period of time, the blade and the mixing tube must be worn and adjusted or replaced according to the wear conditions.
6. Do not insert hands and sticks into the barrel during mixing to avoid danger.
Single-shaft concrete mixer operating procedures 1, first check the rotating part and the cylinder before the start of a scratch phenomenon, if scratch phenomenon should be adjusted.