★ Keep distance from the right and left vehicles First of all, to reduce the speed of high-altitude vehicles , we can refer to the preceding vehicle and try to extend the safety distance. At the same time, we must also keep the distance between the vehicle and the right and left vehicles to prevent the vehicle from colliding sideways when the visibility is low, and avoid the emergency stop to prevent the occurrence of collision. Rear-end accidents, and low road tire adhesion on the road is also prone to out of control or rollover. ★ Beware of illusions caused by squinting When working on a high-altitude vehicle, try to look at a fixed target in the distance. Hold the steering wheel in both hands and go straight. Do not look at the splashes of water or waves on both sides of the vehicle to avoid squinting the line of sight and causing accidents when the vehicle deviates from the normal route. Be careful not to distract attention due to the dazzling and colorful lightning. In addition, splashes of water splash on the front windshield as the vehicles on the left and right are overtaking, gripping the steering wheel with both hands to speed up the wiper and wipe the water, keeping the mind calm. , must not be an emergency brake or hit the direction. ★ See the water Department Mo Zuo flash right avoid It's common people's problem to see the water flash, or immediately put on the brakes to slow down. In fact, these two methods are very dangerous. The disadvantage of the high-altitude vehicles left-right and left-right is that the rear drivers do not know how to respond. The accident is very easy to happen. In fact, if the water depth is about 15 centimeters, it will not have any impact on the car at all, and it can be used at normal speed without worrying about water entering the car or breaking down. It should be noted that when the car is over After the water, the brake system may temporarily weaken, and the brake distance will increase. ★ Correct operation when the vehicle is skid Aerial vehicles are more likely to encounter slippery roads during thunderstorms. The accumulation of water on the roads causes sudden increase in unilateral resistance for vehicles traveling at high speeds. In severe cases, the vehicles make circular movements or lose control. Therefore, the speed should be reduced to help the steering wheel. Pay attention to the road area water. Really have a car slippery, it does not have to be too panic, we must keep calm. If it is the front wheel skid, you should correct the opposite direction of the steering wheel to the side; if it is the rear wheel skid, you want to The steering wheel is corrected in the same direction as the sideslip. ★ The wiper rubber strip is best changed every year If the wiper's ability to sweep water is severely reduced, it is very difficult to drive a high-altitude vehicle in rainy weather. To restore its ability, the key is to replace the rubber strip on the wiper blade. For too long time, most of the rubber strips are aged and cannot be tightly bonded with glass. Because they are glued together, the raindrops on the glass cannot be cleaned. Especially when there is dirt, the performance of the wiper will be further reduced because the dirt is trapped between the rubber strip and the glass. In general, the rubber strip should be replaced once a year. . Compared to metal materials, plastics offer many advantages in cost, design, processing and performance. The inherent design freedom of plastic molding ensures more efficient gear manufacturing. Internal gears, gear sets, worm gears, etc. can be molded from plastic. Plastic gears have a wider application area than metal gears, so they push gears toward higher loads and greater power transmission. Plastic Gear Mold,Plastic Injection Mould,High Accuracy Plastic Injection Moulds,Plastic Small Gear Mould Dongguan Kaisijin Intelligent Technology Co., Ltd , https://www.dgsmartlockoems.com
There are many thunderstorms in summer. How do you drive safely? The manufacturer of high-altitude trucks and the drivers' friends discuss together!