here are two basic types of self adhesive labels: permanent and removable. Each type of adhesive is made from a variety of glues depending on the conditions the label will have to endure, the length of time it is required and the environment or conditions of storage.
Self Adhesive Label use glossy paper, matt material to print CMKY color. It is print by oil, it can be also add series number, QR code, scratch off part in self adhesive label.
Kindly see below self adhesive label, which we can accpet OEM label.
Just need your logo in AI, CDR, EPS file, tks.
Self Adhesive Label Printing,Self Adhesive Labels,Self Adhesive Label 3D Printing Shenzhen Tuteng Anti-Counterfeiting Co., Ltd. , https://www.szholographicsticer.com
Self Adhesive labels are usually coated with an acrylic, rubber or water-based glue. Sticky labels can either be applied permanently or temporally.
Self adhesive labels can printed on by laser printers, inkjet printers, photocopiers or handwritten. Laser printers and photocopiers are a hot process and we recommend that A4 sheets of labels are only printed once for best results. The heat process evaporates the moisture in the adhesive each time it is passed through the printer.
This is a kind of slime sorting equipment successfully developed in China in the early 1960s. Its groove surface is flat, with ribs on both sides, continuous linear motion, large slope of the belt surface, thin film to 1mm, very high flow rate. low, mainly laminar flow, concentrate enrichment ratio, usually used with centrifugal concentrator, the latter will concentrate further selection. The device has a simple structure but low processing power.
The belt chute has been finalized. The specifications are 1000nmm and 3000mm long (including 2400mm in the rough part and 600mm in the selected part). There are mainly single layer and double layer.
The structures of the single and double double belt chutes are shown in Figures 1 and 2, respectively.
The main technical parameters of the single-layer and double-layer 3000mm×1000mm belt chutes produced by Ningde Gravity Selection Plant are as follows:
Belt slope: 13°~17°
Belt speed: 30mm/s
Flow film flow rate: 100mm/s
Recycling size: 0.010~0.074mm
Unit load: 0.3~0.4t/m 2 •d
The belt chutes produced by other factories and their technical parameters are listed in the table.
   figure 1  figure 2  table