Weiliba flowmeter can be used to measure the flow of medium such as underground pipeline industry water, filtered water, circulating water, etc. Because of the large amount of impurities such as sediment, the medium temperature is not very high, generally at room temperature, the pressure does not exceed 1.6Mpa, and the production There are few opportunities for production pipelines to stop production, and there is basically no opportunity for pipelines to be deactivated. At the time of our selection, the solution was to use an online-installed type of Verabar. These probes can be easily removed at any time. Of course, if the user's dust removal effect is good, we also recommend using a non-inline mounting type equipped with a blowback device that can handle most situations. However, if it is to be pulled out for maintenance, it can only be done when the production is stopped, unless a valve or threaded bolt is fitted to block the welding head.

Verabar flowmeter installation:
Installation on horizontal pipelines. When the medium is air and gas, Verabar should be installed at 160° above the upper part. This will ensure that the liquid in the gas will not enter the pressure guiding tube. The transmitter must be installed as high as possible. The position of the bar, when the table is open, the discharge operation. In the case of liquids and vapours, any air bubble can enter the pipeline at any point in the lower part of 160°. When the conditions permit, it can only be installed in the upper part. Then the exhaust operation is performed when the table is opened (the underground pipe is basically the same, In the case of silt in the underground pipeline, it is recommended that the probe should be installed vertically to ensure that the flow of the media on both sides of the probe is similar, so that the pressure hole is more difficult to block). For steam, condensate water is allowed to enter the pressure guiding pipe and flow into the condensing pipe. The device must be installed below the power bar. Installation on a vertical pipe can be installed anywhere around 360° on the vertical pipe (satisfying the straight pipe section). Pay attention to correct the direction of the probe after installation so that the direction of the fluid “→” on the probe and the direction of the pipe fluid remain at 3 ° within.
Due to the low differential pressure calculated by the Verabar flowmeter, it is generally not required to discharge the pollutants. If the pollutants are discharged for a long time, the balance of the probe high-pressure pressure-receiving holes will be broken, which will lead to a situation in which the plugging will be blocked and the pressure will be reduced. The hole is blocked and the flow indication is low after reopening the table. Therefore, in the normal maintenance of the meter, it is emphasized that only the system check and the instrument zero are performed. For particularly important measuring instruments, the power sensor can be cleaned periodically. One time/month, it is required to check the appearance of the probe and the clearing of the positive and negative pressure holes during cleaning. At the same time, in order to ensure accurate measurement of small differential pressure, it is necessary to ensure that the static sealing points of the measurement system do not leak when the installation is resumed.

Rehabilitation Yoga Appliances

Rehabilitation Yoga Equipment plays a crucial role in helping individuals recover from injuries, surgeries, and chronic conditions. These equipment are designed to provide support, stability, and comfort to the body, allowing individuals to perform yoga poses safely and effectively.

Some of the common rehabilitation yoga equipment include:

1. Yoga mats: These provide a comfortable and non-slip surface for individuals to perform yoga poses.
2. Yoga blocks: These are used to provide support and stability to the body during yoga poses.
3. Yoga straps: These are used to help individuals achieve proper alignment and deepen their stretches.
4. Bolsters: These are used to provide support and comfort to the body during restorative yoga poses.
5. Yoga chairs: These are designed to provide support to individuals with limited mobility or injuries, allowing them to perform yoga poses safely.
6. Yoga wheels: These are used to improve flexibility, balance, and strength by providing support and stability to the body during yoga poses.
Overall, rehabilitation yoga equipment plays a vital role in helping individuals recover from injuries and chronic conditions, allowing them to improve their physical and mental well-being through yoga practice.

Rehabilitation Yoga Appliances,Latex Resistance Bands,Exercise Rubber Bands,Fitness Yoga Strap

Changzhou Golden Oak Rubber Plastic Polymer Co.,Ltd , https://www.czjnsatee.com